The Fuel Filter in your Ford Escape model does a great job of trapping grime and particles that attempt to make their manner into the fuel system. Nonetheless, for those who neglect the system, the filter will start to clog, restricting gas flow and energy to the engine. Finally, you may actually have a arduous time starting the vehicle. Earlier than that happens, follow this information to replace the Fuel Filter and keep full energy coming out of your Ford engine.

Relieve Ford Escape Fuel Filter System Pressure

1. Unplug the fuel pump relay located in a relay assembly inside the engine compartment.
2. Begin the engine and let it idle. Once it stalls, crank the engine for about five seconds to relieve the residual pressure within the system.
3. Turn the ignition key to the “Off” position.
4. Disconnect the black, damaging battery cable using a wrench.

Ford Escape Fuel Filter Removal Instructions

1. Elevate the rear of your Ford Escape using a floor jack and assist it on two jack stands.
2. Find the filter along the underside of the car, close to the gas tank.
3. Remove the locking tabs that hold the fuel strains to the filter on each side. Press the tab legs on all sides of the becoming along with your fingers while pulling the back tab with a small screwdriver. Once released, pull the tab from the road becoming and take away the other tab.
4. Cowl the fittings with a store rag as you pull the strains off the filter to catch any fuel remaining in the line.
5. Loosen the clamp holding the filter to the vehicle chassis utilizing a screwdriver or ratchet and socket.
6. Take away the fuel filter from the vehicle.

Ford Escape Fuel Filter Installation Instructions

1. Set the brand new filter in place and ensure the arrow on the filter points towards the front of the vehicle.
2. Tighten the fuel filter clamp using the screwdriver or ratchet and socket.
3. Attach the fuel traces to the fuel filter fittings.
4. Set up new lock tabs to the fittings to safe the fuel traces to the filter.
5. Decrease the vehicle.
6. Plug the fuel pump relay.
7. Connect the black, adverse battery cable utilizing the wrench.
8. Flip the ignition key to “On” but don’t start the vehicle. Make sure that there are no leaks on the filter connections.
9. Start the engine and let it idle. Double-test for leaks.